To set up your computer or other device to synchronize to the SiteSync IQ Remote Transmitter, simply enter the IP address of the Remote Transmitter as the time server address for the computer or device.
This document explains how to configure NTP in wireless LAN devices, such as Wireless LAN Controller (WLC), Wireless Control System (WCS), and Wireless Location Appliance. In a Unified Wireless Network, it is essential that the WLCs, Location Appliance, and WCS use NTP in order to have a common clock source. This document explains how to synchroniz... See full list on cisco.com Requirements There are no specific requirements for this document. Components Used This document is not restricted to specific software and hardware versions. Conventions Refer to Cisco Technical Tips Conventionsfor more information on document conventions. See full list on cisco.com With the recent change in the start and ending date of DST in the United States, the controller will display an incorrect local time (1 hour off if DST is enabled) in the logs between these times: 1. 2:00 a.m. on the second Sunday in March until 2 a.m. on the first Sunday in April (between the start of the new DST and the start of the old DST time)... See full list on cisco.com This section provides the configuration steps in each of the Unified Wireless Network devices that must be completed in order to configure NTP. Note: Use the Command Lookup Tool (registeredcustomers only) to obtain more information on the commands used in this section. See full list on cisco.com Use this section to confirm that your configuration works properly. The Output Interpreter Tool (registered customers only) (OIT) supports certain show commands. Use the OIT to view an analysis of showcommand output. 1. timeShows the actual time of the server where the WCS is installed. 2. dateShows the actual date of the server where the WCS is ... See full list on cisco.com This section provides information you can use to troubleshoot your configuration. If time is not synchronized between the WCS, Location Appliance, and the WLCs, the logs provide information that is hard to relate between devices. See full list on cisco.com See full list on cisco.com In this guide, we will walk you through the process of using Net Time to remotely configure the time on a workstation within a domain. We will cover the necessary steps and provide you with troubleshooting tips to ensure a seamless experience. System time is the time displayed while the router is running. The system time you configure here will be used for other time-based functions like Parental Controls. Read this article for information on CA Certificate installation and configuration, as well as setup for Time Servers (Network Time Protocols/NTP). View online or download American time SiteSync IQ Installation And Operation Manual, Quick Start Installation Manual, Quick Start Manual. Read this document and the documents listed in the additional resources section about installation, configuration, and operation of this equipment before you install, configure, operate, or maintain this product.
